Agfa: Staying Ahead of the Technology Curve


Reading time ( words)

Matties: So there are three areas: the solder mask, the legend, and what is the third area?

Van Dam: The etch resist. That's commercial, so there we have some interesting projects. Currently, the majority is in the chemical milling market. But we are also testing in the PCB application.

Matties: Is there anything that we haven't talked about that we should share with our readers?

Van Dam: Yes, in addition to the products for the PCB market, Agfa also has products for printed electronics. Our Orgacon range has products based on conductive polymers and nano silver. We have a nano silver inkjet ink commercially available. This goes a step further in additive technology.

Matties: It's really a booming area. Nano Dimension is doing this kind of technology with their Dragonfly and they were just approved by the U.S. military for this technology, I believe. It really paves the way for so many of the other companies to step in, because there is now some proven ground. And then the presentations that we're seeing here in which they’re printing circuits on the molded surfaces for automotive really changes the whole landscape of circuit boards. What is your take on that?

Van Dam: We are also highly focused on that; we want to be there for the future, so we know this is an important area and we have a significant team looking into these type of applications.

Matties: We are planning an issue on megatrends, and one of the megatrends that we see is 3D printing. Not just 3D electronics, but 3D printing in connection with 3D electronic printing, because when you can put the power of creation on the desktops of individuals, it changes the world. When the personal computer landed in the hands of the general population, look what happened. And I think we're going to see the same thing and same innovation with 3D printing.

Van Dam: Agreed. 3D printing and integrating electronics in the shapes like we saw today is quite interesting.

Matties: It is very exciting. Thank you for your time and congratulations on your new position as global sales manager.

Van Dam: Thank you very much.

 

Share

Print


Suggested Items

Future Trends in Flying Probe Testing

11/29/2019 | I-Connect007 Editorial Team
Peter Brandt, director of sales for Europe and Japan at atg, sits down with Pete Starkey and Barry Matties, gives his views on market requirements and testing technologies, and explains how flying probe testing is becoming the industry standard at all levels of production—and in many cases, the only practicable solution.

Decreasing Bend Radius and Improving Reliability- Part II

11/22/2019 | Kelsey Smith, All Flex
Many of the issues that arise when using a flex circuit come from a lack of knowledge about how to properly design one, especially when the circuit is required to bend. Many novices will design a circuit that calls for bending the flex in too tight of a bend radius, which can cause damage to the circuit and lower the reliability of the end product. This series of articles will focus on the seven key aspects to consider when designing for maximum durability and maximum “flexibility”.

Solder Mask Tack Dry

11/08/2019 | Nikolaus Schubkegel
As a general rule, the tack-dry temperature should be as low as possible; in other words, it should only be as high as necessary. If the temperature is too low, the evaporation rate for the solvent will be to slow, and the solder mask will not dry in a reasonable amount of time. If the temperature is too high, however, the dry time certainly will be excellent, but it could create a solder mask lock-in with repercussions by the developing time.



Copyright © 2019 I-Connect007. All rights reserved.